Lada Kalina, User Manual

Page: 42 / 168

ing on the ignition and after engine
start it goes out.
ATTENTION!
In all other cases, lighting of
the alarm means a fault, repair of
which should be done only at any
certified SSNE.
24 – safety belt reminder (in the
design variant).
It lights red when switching on the
ignition if seat belts are not fastened.
When driving at a speed of more than
10 km/h switching of the light indica-
tor is immediately duplicated with an
intermittent horn of the buzzer; at a
speed of up to 10 km/h the horn will
sound after 60 seconds of non-stop
driving.
Warning
When driving be sure to fasten
your seat belt and do not carry
unbelted passengers!
25 – transmission malfunction
indicator (in the design variant) .
26 – airbag indicator. It lights
orange when switching on the igni-
tion and it goes out at the end of ABS
self-test mode (about 3 seconds).
When switching on the ignition the
indicator does not light up in the self-
test mode; this indicates a malfunc-
tion of the system, in this case, you
should contact any certified SSNE as
soon as possible.
ATTENTION!
In all other cases, lighting of
the indicator means a fault, repair
of which should be done only at
any certified SSNE.
27 – hazard indicator. It blinks
red when pressing the hazard switch
button.
The instrument cluster has a
self-test mode. To activate the self-
test mode, press the trip counter
switch button, then switch on the
ignition, holding the button (not
starting the engine).
After switching on the ignition the
needles of indicating instruments
(tachometer and speedometer) will
move from zero to maximum (4 times),
while on the liquid crystal display
(LCD) all segments will light and all
alarms and LEDs will be switched on,
controlled with the microcontroller of
the instrument cluster.
For the design variant of the
instrument cluster with the trip com-
puter without displaying the outside
temperature:
– OverDrive indicator, ABS, trans-
mission fault, tire fault, unclosed
doors.
For the design variant of the
instrument cluster with the trip com-
puter and displaying the outside
temperature:
– main beam, dipped beam, ESC,
ESC OFF.
If in the self-test mode you press
the trip counter switch button, then
LCD will display the number of instru-
ment cluster software on the top line
of the LCD and the number of instru-
ment cluster on the middle line. Self-
test mode will stop in 25 seconds
after it starts, or when the signal of
speed or revolutions of the engine
shaft appears.
40