7
Initial operation
7.6
Adapting hydraulic system
80
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
Calculating displacement path
Calculating the displacement path “V” (overlap):
V=X-Y.
Æ
The displacement path (overlap) must be at least
V≥220 mm
.
Checking shortened universal shaft when driving around curves
Drive a right or left curve with the tractor. In doing so, observe the marking (5).
Æ
The outer guard tube must not touch the marking (5) in the narrowest position (cornering
with maximum steering angle and simultaneous driving up and driving down a slope).
If the outer guard tube touches the marking (5), shorten the both universal shaft halves
by the same length as described above until the outer guard tube does no longer touch
the marking.
7.6
Adapting hydraulic system
For “Comfort 1.0” version
1
BPG000-018
Move the control units on the tractor into float position.
Depressurise the hydraulic system on the tractor and the machine.
Shut down and safeguard the machine,
.
Operation of the machine on tractors with constant flow system
For tractors with open hydraulic system.
Unscrew the system screw (1) as far as it will go.
Operation of the machine on tractors with Load Sensing system
For tractors with closed hydraulic system. In doing so, the signal line is connected.
Screw in the system screw (1) as far as it will go.
7.7
Setting the bale chute
When it is unfolded, the bale chute represents an extension of the bale channel. In order to
make sure that big bales are set down on the ground correctly, the back edge of the bale chute
must not be set too high above the ground. Otherwise the bales will be damaged when they are
placed on the ground.
