Krone Big Pack 1270 XC, Original Operating Instructions

Page: 79 / 448

Initial operation 7
Adjusting universal shaft (for the version with “PreChop”) 7.5
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 79
Mounting protective cap
1 2 3
BP000-406
„
Slide on the protective cap (2) and align it so that the both openings (1) are in alignment with
the slide ring locks (3).
„
Slide on the protective cap (2) until both slide ring locks (3) engage audibly in the openings
(1).
Determining displacement path (overlap)
X
Y
1 2 3 4 5
1
4
6
7
8
BP000-404
„
Position the universal shaft halves (1, 4) so that the outer section tube (3) is located in front
of the inner section tube (2).
„
Determine dimension “X”.
„
Assemble the universal shaft halves (1, 4) until the stop is reached.
„ At the end of the outer guard tube, draw a marking (5) on the inner guard tube.
„
In order to facilitate the assembly of the universal shaft half (4), push back the protective cap
(6),
refer to page 73 .
„
Slide the universal shaft half (1) on the tractor PTO shaft until the lock snaps into place
automatically.
„ Dismount the clamping bridge (7).
„
Slide the universal shaft half (4) on the machine PTO shaft until the boreholes of the
clamping bridge (7) protrude beyond the annular groove.
„ Mount the clamping bridge (7) by means of the screws (8). Tightening torque: M12=80 Nm,
M14=130 Nm, M16= 200 Nm.
„
Bring the machine into the widest position (straight-ahead driving).
„ Shut down and safeguard the machine, refer to page 26 .
„
Determine the dimension Y.