Konica Minolta Di5510, Advanced Information

Page: 446 / 488

8 Troubleshooting
8-4 Di5510/Di7210
If there are any other technical problems:
G switch the system off,
G remove the power plug from the outlet and
G contact the technical representative.
The copies are output
reduced or enlarged
although the magnification
ration is set to 1:1. The AMS feature is enabled. Press [APS] or [1,000] for
copies of the same size.
The cycle was interrupted. There is a paper jam. Clear the paper jam.
The copy limit has been
reached. Talk to the system
administrator.
The system copies
immediately after the warm-
up phase. You pressed the [Start] key
on the control panel during
the warm-up phase. Do not make system settings
until the display shows
Copier ready .
The EDH will not feed
originals. The paper size or the paper
thickness is not correct. Place the original on the
original glass.
The EDH is overloaded. Load the up to 100 originals.
The finisher is not working. There is a paper jam. Clear the paper jam.
The finisher door is open. Close the finisher door.
No finisher function is
enabled in the output menu. Check the settings in the
output menu.
The finisher is stapling at the
wrong position. Automatic rotation is
enabled. Change the position of the
original to prevent rotation.
The hole punch unit is not
working. The waste container is full. Empty the hole punch unit
waste container.
Symptom Possible Cause Action