Juniper SRX550, Hardware Manual

Page: 143 / 220

Table 36: Component LEDs on the Services Gateway Chassis (continued)
Usage Location LED
The HA LED has the following indicator colors:
•
Green and steadily on indicates all configured high
availability links are available.
•
Red and steadily on indicates cluster member missing
or unreachable.
•
Amber and steadily on indicates that some
configured high availability links are down, but
enough links are still active for full high availability
functionality. In this situation performance might be
reduced, current bandwidth could cause packet
drops, or single point of failure might now exist.
•
Off indicates that HA is not enabled.
Left side of the front
chassis panel
HA
NOTE: ACE LED is not functional. Left side of the front
chassis panel
ACE
Green and steadily on indicates that the redundant
power supply is operating normally.
Red and steadily on indicates that one of the following
conditions has occurred:
•
The primary power supply has failed, and the device
is being powered by the redundant power supply.
•
The redundant power supply has been installed, but
is not connected to a power source.
Left side of the front
chassis panel
RPS
Green and steadily on indicates that the Mini-PIM in
the corresponding slot is functioning normally.
Red and steadily on indicates that the Mini-PIM
hardware in the corresponding slot has failed or its
anti-counterfeit check failed.
Off indicates that there is no Mini-PIM in the
corresponding slot, or that the Mini-PIM is not detected
by the device.
Left side of the front
chassis panel
MPIM-1 and MPIM-2
RELATED DOCUMENTATION
127