Juniper SRX550, Hardware Manual

Page: 151 / 220

access to a services gateway, you can delete the invalid configuration and replace it with a rescue
configuration by pressing the RESET CONFIG button. The button is recessed to prevent it from being
pressed accidentally.
The rescue configuration is a previously committed, valid configuration. You must have previously set the
rescue configuration through the J-Web interface or the CLI.
To press the RESET CONFIG button, insert a small probe (such as a straightened paper clip) into the pinhole
on the front panel.
CAUTION:
•
By default, pressing and quickly releasing the RESET CONFIG button loads and
commits the rescue configuration through the J-Web interface or the CLI. (For details,
see the CLI Explorer .)
•
By default, pressing and holding the RESET CONFIG button for 15 seconds or
more—until the STATUS LED blinks red—deletes all configurations on the services
gateway, including the backup configurations and rescue configuration, and loads
and commits the factory configuration.
For details about factory-default settings, see Viewing Factory-Default Settings of the SRX650 Services
Gateway.
For details about performing initial software configuration, see Configuring Basic Settings for the SRX650
Services Gateway with the CLI or the J-Web Interface.
RELATED DOCUMENTATION
SRX550 Services Gateway Front Panel | 15
Troubleshooting with the CLI on the SRX550 Services Gateway | 125
Troubleshooting with LEDs on the SRX550 Services Gateway | 126
Troubleshooting the Power System on the SRX550 Services Gateway | 130
Changing the RESET CONFIG Button Behavior on the SRX550 Services Gateway | 136
Resetting the SRX550 Services Gateway | 137
135