Juniper SRX550, Hardware Manual

Page: 127 / 220

3. Configure basic network settings.
In a typical network, the services gateway has the basic settings listed in Table 31 on page 111 . Determine
the values to set on the services gateway in your network.
Table 31: Sample Settings on the SRX550 Services Gateway
Sample Value SRX550 Services Gateway Property
devicea Services gateway hostname
10.0.0.1/24 IP address for default gateway
10.148.2.21 IP address of the NTP server used to synchronize system
time
10.148.2.32 IP address of the DNS server to which DNS requests are
sent
lab.device.net and device.net Domains to which the services gateway belongs
You can configure basic settings for the services gateway using either the J-Web setup wizard or CLI as
the configuration editor. Table 32 on page 111 summarizes the configuration tasks for the initial setup for
both required and optional settings.
Table 32: Configuring Basic Settings
Using the CLI Using the J-Web Setup Wizard
Required or
Optional Task
Navigate to the top of the
configuration hierarchy in
the CLI. From the [edit]
hierarchy level, type:
edit system
After establishing basic connectivity
and entering root as the default
username (see “Connecting to the
SRX550 Services Gateway from the
J-Web Interface” on page 98 ), click
Enter. The J-Web setup wizard
appears. Click Start at the bottom
of the Introduction page.
Required Navigate to Configure
System: Identification
page.
Specify the hostname. For
example:
set host-name devicea
On the Configure System:
Identification page, type the
hostname of the services gateway;
for example, devicea.
Required Define the hostname of
the services gateway.
111