Juniper SRX550, Hardware Manual

Page: 116 / 220

Figure 26: Ethernet Cable Connector (RJ-45)
4. Connect the other end of the Ethernet cable to the built-in Ethernet port 0/1 on the services gateway.
5. Power on the services gateway by connecting the power cord or by pressing the Power button on the
front of the services gateway.
6. Wait until the STATUS LED on the front panel turns solid green.
7. Turn on the power to the management device. The services gateway assigns an IP address to the
management device within the 192.168.1.0/24 network if the services gateway is configured to use
DHCP.
8. From the management device, open a Web browser and enter the IP address 192.168.1.1 in the address
field.
9. Specify the default username as root. Do not enter any value in the Password field.
10. Press Enter. The J-Web setup wizard appears.
NOTE: The upper left area of the wizard page shows where you are in the setup process.
Click a field in the wizard page to display information about that field in the lower left area
of the page.
11. Use the wizard to configure basic settings such as hostname, domain name, and root password for your
services gateway. You can also use the wizard to configure a default gateway, DNS servers, domain
search, VLANs, interfaces, and the J-Web interface preferences. For details on using the J-Web setup
wizard to configure basic settings for the services gateway, see “Configuring Basic Settings for the
SRX550 Services Gateway with a Configuration Editor” on page 110 .
12. Click Commit to apply the configuration. After configuring the basic settings, you are prompted to log
out. Relaunch the page to see the settings and continue working in the J-Web interface.
100