Juniper SRX550, Hardware Manual

Page: 83 / 220

CHAPTER 14
Installing the Mounting Hardware
IN THIS CHAPTER
Preparing the SRX550 Services Gateway for Rack-Mount Installation | 67
Connecting the SRX550 Services Gateway to the Building Structure | 68
Preparing the SRX550 Services Gateway for Rack-Mount Installation
You can mount an SRX550 Services Gateway on four-post (telco) racks, enclosed cabinets, and open-frame
racks. Center-mount racks are not supported.
Before mounting the SRX550 Services Gateway in a rack:
•
Verify that the site meets the requirements described in “Site Preparation Checklist for the SRX550
Services Gateway” on page 33 .
•
Verify that you have the following parts available in your rack-mounting kit for the SRX550 Services
Gateway:
•
Rack-mounting brackets
•
Eight mounting screws to attach the mounting brackets to the chassis of the services gateway
•
Four mounting screws to attach the mounting brackets to the rack rail
•
Verify that the racks or cabinets meet the specific requirements described in “SRX550 Services Gateway
Rack Size and Strength Requirements” on page 43 .
•
Place the rack or cabinet in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure. For more information, see “SRX550 Services Gateway
Cabinet Airflow Requirements” on page 48 .
•
Remove the gateway chassis from the shipping carton. For unpacking instructions, see “Unpacking the
SRX550 Services Gateway” on page 64 .
RELATED DOCUMENTATION
67