Jung J630D, Manual

Page: 253 / 316

J630D
8. Error and status messages 26.7.02 247
65016 Invalid wheel radius for S output
Situation: Machining Dressing, Tool Management-Spindle Speed-Output.
Conse-
quences: The machining operation is interrupted.
Meaning: The radius for the spindle speed output has been entered incorrectly
(limit values) !!
What to do: Check the limit values and change them if necessary.
Enter the wheel radius for the spindle speed output in the tool manage-
ment mask.
65017 No probing control data
Situation: Machining Probe.
Conse-
quences: The actual-value setting function is interrupted.
The grinding operation does not start.
Meaning: Either the feed rate data or the probing control data is missing.
What to do: Enter the data.
65018 No probing control signal
Situation: Probing while setting actual values.
Probing during plunge grinding.
Conse-
quences: Machining Actual Values or the grinding operation is interrupted.
Meaning: The probing path is too short, the direction is incorrect or the device is
defective: the settings must be checked.
What to do: Check the probing path and the device function.
65019 Cannot find probe
Situation: When the PA 31K diamond is measured.
Conse-
quences: The search for the measuring position is interrupted.
Meaning: The V and W-axes must be set roughly to the measuring position < 0.5
mm before you press “Find Meas. Pos.“.
What to do: Set the diamond roughly to the measuring position.
Start the program again.
Check the function of the measuring device; the probe may be defec-
tive.