Jung J630D, Manual

Page: 72 / 316

J630D
66 26.7.02 4. Functional description of the operating modes
Alternatives:
• You can enter settings with 0.52 inch + or - increments using the scroll keys
(See section 3.1 “Control unit” on page 47, position 9D, 19D).
• You can enter settings with 0.01 inch + or - increments using the arrow up and
arrow down keys. (See section 3.1 “Control unit” on page 47, position D8, D12,
D18, D20).
• You can also enter these settings using the mouse.
When you have finished entering the settings, press the "Accept Values" soft-
key. The new values are not activated until you do so.
4.3.1.10 Teaching an X- or Z-axis reversing position with the remote control
panel
• Traverse to a future reversing position with the X- or Z-axis.
• Press the teach key (See section 3.3 “Remote control panel” on page 55, po-
sition 12) on the remote control panel and then one of the direction keys (+ or
-) depending on whether you want to teach the + or - reversing position.
• Traverse to the second reversing position.
• Press the teach key (See section 3.3 “Remote control panel” on page 55, po-
sition 12) again and then the other direction key (+ or -), in order to teach the
second position.
Diagram of axis positions
If you want to save the positions you have entered with the teach
function in an automatic program, you must press the "Read NCU
Data" softkey subsequently in the "Program Jung" module.
Wheel
Wheel Wheel
Wheel
Z+
Z-
X- X+
Magnet