Jung J630D, Manual

Page: 201 / 316

J630D
6. Dressers 26.7.02 195
6.3 AT35 / AT35D (Option)
You can use this dresser to dress the outside contours by numerical control.
The diamond block with the diamond holders can be mounted on either side of the
machine table, depending on the application. It is usually mounted on the left-
hand side of the magnet.
If you are using the AT35D model (double station), the two stations must be moun-
ted side by side. It is advisable to use the station mounted closer to the magnet
as the finishing station.
Diamond nos. 1 and 2 of the roughing and finishing station are mounted in dia-
mond holders at an angle of 45°. You can use these diamonds to dress the outer
contours of the grinding wheel. You must remove the no. 3 diamonds of the
roughing and finishing station, including the diamond blocks, beforehand.
The no. 3 diamonds of the roughing and finishing station are mounted vertically in
the diamond holders. You can use these diamonds to dress the perimeter side of
the grinding wheel. You may have to remove diamond nos. 1 and 2 beforehand,
depending on the thickness of the wheel and the height of the diamonds..
If you use the AT35 / AT35D, the magnetic chucks must not be longer
than 450 mm.
You should adjust the dressing height to the height of your magnet
or workpiece by means of the intermediate plates supplied with the
machine. The dressing height must never be greater than the grin-
ding height.