Jung J630D, Manual

Page: 43 / 316

J630D
2. Technical data / transportation / commissioning 26.7.02 37
2.6 Preparation for commissioning
• Unpack the machine carefully. Damaged packaging materials cannot be retur-
ned.
• Check that the machine accessories are complete.
• Stand the machine up carefully onto its feet.
• Align the machine carefully using the levelling screws and a spirit level.
• Position the machine where you want to install it and remove the transportation
safeguards (see sketch below).
– Loosen the transportation safeguard for the grinding head.
– Remove the transportation safeguard for the reciprocating table (X-axis)
• Charge the machine with lubricant. Heed the safety instructions concerning the
use of oil.
• Plug in the electrical connectors and connect the power supply. This step must
always be carried out by a qualified electrician in accordance with the generally
recognized rules of sound electrical practice. See section 2.8 “Electrical con-
nections” on page 43.
The machine is only allowed to be installed and connected by trai-
ned, authorized persons. The manufacturer cannot under any cir-
cumstances accept liability for damage resulting from inexpert
installation. Please also study and heed the original instructions pro-
vided by the suppliers of accessories.
If you do not intend to install the machine immediately, please read
the instructions contained in the “Temporary storage” section care-
fully.
Always follow the transport instructions when raising or transpor-
ting the machine. See section 2.5 “Transport instructions” on
page 33.
Never stand underneath the raised machine. Risk of fatal injury.