Jung J630D, Manual

Page: 285 / 316

J630D
9. Maintenance / servicing / disposal 26.7.02 279
9.3 Lubrication plan
9.3.1 Important instructions for working with oils
9.3.2 Recommended lubricating oils
Standard designation:Lubricating oil CGLP 220 / ISO-L-G 220
JUNG designation: JUNG oil 220
9.3.3 Recommended hydraulic oils
Standard designation:Hydraulic oil HLP 22 / ISO-L-HM-22
JUNG designation: JUNG hydraulic oil 22
9.3.4 Recommended grease (for optional PA31K)
ISO FLEX NBU 15 (Klüber)
The machine must not be started up until the central lubrication sys-
tem has been filled with one of the specified oils. No liability will be
assumed by the manufacturer for any damage to the machine which
results from failure to comply with this requirement.
Study and heed the general rules and requirements for working with
oil.
Avoid direct contact between your skin and the oil by wearing perso-
nal protective equipment (gloves, special work clothing, etc.).
If oil comes into contact with your skin despite all precautions, you
should immediately wash and rinse the affected areas thoroughly.
See section 7.3.2 “Skin protection plan” on page 223.
Spilt or leaked oil is slippery. Wipe it away immediately to avoid acci-
dents.
Please refer to the DIN Material Safety Sheets provided by the oil
manufacturer for information about the safety-relevant characteris-
tics of your particular oils (flash point, etc.).
Please dispose of used oil in a proper and environmentally compa-
tible manner. Any statutory requirements must be observed.