Jung J630D, Manual

Page: 76 / 316

J630D
70 26.7.02 4. Functional description of the operating modes
• Check the dressing diamond (wear, correct radius and angle) and mount it in
the dresser.
• Check that you have selected the correct dresser.
• Enter the diamond data in the tool management mask.
• Select a grinding wheel.
• Prepare the grinding wheel [flange on, balance, pre-dress at the perimeter
and the faces, re-balance (preferably dynamically) and measure].
• Enter the grinding wheel data in the tool management mask.
• Create a contour program (Grips with swivel angle calculation, etc.).
• Position the grinding wheel at the dressing diamond (table dresser) or vice
versa (head dresser).
• Run the Actual Values Dressing function.
• Create the dressing technology.
• Start the dressing program (a contour negative is created for the grinding
wheel).
• Measure the workpiece (in order to enter the grinding geometry).
• Fix the workpiece onto the grinding table (magnetic table, vice, etc.).
• Probe the workpiece with the dressed grinding wheel (possibly automatical-
ly on the basis of the structure-borne noise).
• Run the Actual Values Grinding function.
• Create the grinding technology (reciprocating plunge grinding or creep-feed
grinding) and the grinding geometry.
• Adjust the coolant nozzles correctly.
• Make sure that the automatic program can be executed safely (traverse
paths clear, guard doors closed, all safety devices active).
• Start the automatic program.
Possible ways to intervene during a program cycle
– Program stop
– Measurement
– Start a dressing program manually by pressing a key