Technical Documentation
opti-check
v2.8.2-K11
284/332
ipf electronic GmbH
Lüdenscheid, Germany
15.4.11 SP command
– set parameters for the feature checks
This function enables you to set the expected values for the feature checks.
The expected values are set temporarily and remain valid until the device is restarted or switches to
configuration mode.
To save it long term, activate:
Device → Device settings→ Job selection / Teach → Save changed
parameters from external Teach or process interface command XX to device…
NOTE
You can set the content of the datagram for output via the process interface during job
creation under
Configure interface → Output process interface
.
NOTE
When setting the exposure time for the job, the "Camera ready" signal must be active
before the next image can be acquired.
