Technical Documentation
opti-check
v2.8.2-K11
152/332
ipf electronic GmbH
Lüdenscheid, Germany
downwards (single)
: The search for edges starts at the top edge of the field of view.
upwards (single):
The search for edges starts at the bottom edge of the field of view.
inwards (single):
The search for edges starts at the outer edge of the circle.
outwards (single):
The search for edges starts at the inner edge of the circle.
to the centre line (double):
The search for edges begins from both sides.
outwards (double):
The search for edges begins from the centre line.
The following table provides an overview of which methods are available for which types of field of view.
Rectangle
Circle / sector
single
double
single
double
downwards
x
upwards
x
inwards
x
outwards
x
to the centre
line
x
x
outwards
x
x
Pixel:
Pixels are used as the default preset value if you have not defined your own unit.
[Units]:
If you have defined your own unit (
Adjust image
→
Coordinates
), you can select it here.
Distance:
Here, you can set the
spacing between the search beams.
Alignment:
Define how the search beams are to be aligned.
to the field of view:
The search beams are aligned according to the orientation of the field of view.
to the object:
The system searches for a straight (rectangular field of view) or circular (circular or
sector field of view) reference line. The search beams are aligned perpendicular to the reference
line.
Tolerance field:
Here, you have the option to configure the size of the tolerance range. The
tolerance range is the range between the set minimum and maximum values. The system will test
whether each distance located falls within or outside of this range.
It is shown as a transparent
orange area in the field of view.
Specifications for the edge search
Define the specifications for the edge search.
Min. edge length:
You must also specify whether a short, medium or long edge is to be sought.
Using User defined, you may manually enter the length of an edge (5-1000 pixels)
.
