Technical Documentation
opti-check
v2.8.2-K11
11/332
ipf electronic GmbH
Lüdenscheid, Germany
ATTENTION!
Incorrect supply voltage will destroy the device!
Pin 1: Power (+18…30 VDC)
Pin 2: Ground
ATTENTION!
The device can become damaged by strong radiation or electrical fields.
For this reason, never place the device near strong radiation sources or strong electrical
fields. These can occur in close proximity to lasers, for example.
ATTENTION!
The Vision Sensor is a class A device (DIN EN 55022:2011). It can cause radio
interference in residential environments. Should this happen, you must take reasonable
measures to eliminate the interference.
WARNING!
The device emits bright, pulsed light (Risk group 1, low risk, EN 62471:2008).
Bright, pulsed light can cause damage to the eyes and seizures.
Never look directly into the pulsed light from the LEDs!
For devices with infra-red illumination
NOTE
The device uses LED illumination of the risk group RG 0 (exempt group, no risk) as per
IEC/EN 62471.
The radiation of the LEDs does not pose a hazard to the human eye if the device is used
for its intended purpose.
Even so, do not look directly into the light source
– there is a danger of dazzle and
irritation. Mount the device
so that it is not possible to look directly into the light source.
