iPECS LIP-7004N, User Manual, Page: 94 / 586

LIP-7008D User Guide
42
9. Working with PBX, Centrex & ISDN features
9.1 Access PBX or Centrex
The iPECS has been designed to operate with a host PBX system or
Centrex services from your service provider. The iPECS connects to
such a host with analog CO lines.
When accessing a CO line, the phone will act as an extension of the host,
allowing access to the host system features using the host dial codes.
While on a call, use the iPECS
Flash
feature to transfer calls to other
host extensions or access features of the host. The
Flash
feature may
be used on other CO lines to regain dial tone from the CO line without
relinquishing control of the CO line to place another call.
OPERATION
To access PBX or Centrex features while idle:
 Lift the handset,
 Select/dial access a PBX/Centrex CO line,
 Dial PBX/Centrex feature code.
To access PBX/Centrex features while on a PBX/Centrex CO line:
 Press F
LASH
,
 After receiving new dial tone, dial PBX/Centrex feature code.
9.2 Access the ISDN Network
9.2.1 Using the Keypad facility to access ISDN features
Access to certain features of your ISDN services requires that dialed
digits be sent to the ISDN as data and not tones. In this case, dialed
digits are sent as ‘Keypad messages’.
A
KEYPAD FACILITY
button must be assigned using the
Flex Button
program
procedures. Once active, dial into the ISDN for services;
however, actions other than dialing will deactivate the ‘Keypad message’
operation.
OPERATION
To activate Keypad Facility operation:
 Press the K
EYPAD
F
ACILITY
button to switch to keypad mode,

Dial as desired.
To deactivate Keypad Facility operation:
 Press K
EYPAD
F
ACILITY
,
Or
 Press a Feature or Flex button.