INVT IPE300 Series, Opeartion Manual

Page: 74 / 383

IPE300 series engineering VFD Basic operation guidelines
-63-
 If static autotuning is selected for motor autotuning, there is no need to disconnect the motor from
the load, but the control performance may be impacted as only a part of the motor parameters
have been autotuned. In addition, autotune P02.06
–
P02.10 for AMs and autotune
P02.20
–
P02.22 for SMs. P02.23 can be obtained through calculation.
 Motor autotuning can be carried out on the present motor only. If you need to perform autotuning
on the other motor, switch the motor through selecting the switch-over channel of motor 1 and
motor 2 by setting the ones place of P08.31 .
Related parameter list:
Function
code
Name Description Default
P00.01
Channel of running
commands
0: Keypad
1: Terminal
2: Communication
0
P00.15
Motor parameter
autotuning
0: No operation
1: Rotary autotuning.
Comprehensive motor parameter autotuning. It
is recommended to use rotating autotuning
when high control accuracy is needed.
2: Static autotuning 1 (comprehensive
autotuning); static autotuning 1 is used in cases
where the motor cannot be disconnected from
load.
3: Static autotuning 2 (partial autotuning); when
the present motor is motor 1, only P02.06 ,
P02.07 , and P02.08 are autotuned; when the
present motor is motor 2, only P12.06 , P12.07 ,
and P12.08 are autotuned.
0
P02.00 Type of motor 1
0: Asynchronous motor (AM)
1: Synchronous motor (SM)
0
P02.01 Rated power of AM 1 0.1
–3000.0kW
Model
depended
P02.02 Rated frequency of AM 1 0.01Hz
–
P00.03 (Max. output frequency) 50.00Hz
P02.03 Rated speed of AM 1 1
–36000rpm
Model
depended
P02.04 Rated voltage of AM 1 0
–1200V
Model
depended
P02.05 Rated current of AM 1 0.8
–6000.0A
Model
depended