EloStar Master 3X0 / 4X0 / - smart
Operation
Manual V.1.03H
96
7.15.4.2
Changing Locks
is the sequel of
„Registering a Lock“ in case you replace a lock, but do no extend the
system by adding a new lock. Also see
„Additional Lock“ above.
1.
Follow the steps 1-3 of paragraph
„Registering a Lock“.
Regist. New lock | New lock
is on display.
2.
With < or > and Enter select
Change lock
.
Change lock
and
Lock 1<
are on display.
3.
With < or > and Enter select the lock to be replaced.
Insert bus cable !
is on display.
4.
Connect the cable and confirm the connection with Enter.
Error com | Setup error
would be on display if
the „new“ lock had been
addressed before.
Serial number | Lock 2/3
,
Code entry
,
System manager
,
0123456789
, as the case may be, and
Code:
are on display .
5.
Enter the system manager code.
Serial number | Please wait
is on display.
The serial number of the operating unit is stored within the lock.
Serial number | Saved
is on display.
Lock | Registered
and
EloStar Master | 29.07.19
are on display.
6.
Test opening and closing and, if a bolt work switch is part of the system, examine
whether it has been connected properly.
You have successfully registered a new lock.
