ICP DAS WISE User Manual
http://wise.icpdas.com
72
Figure 6-22
：
The “Scan” button to search ICP DAS module
ii.
When the Scan page appears, input the starting address and the
ending address of the Modbus address that are going to perform
scan. Click on “Scan”, the system will start to scan the ICP DAS
modules that match the settings previously set, to cancel the scan,
and click on “Cancel”.
Figure 6-23
：
Set up the Scanning Range for the ICP DAS module
iii.
When the system is performing the scan, the address that are
performing scan will be dynamically shown on the upper left side,
please wait till the scan operation is completed. To stop the scan
operation, click on “Cancel” to terminal the scan and leave the page.
Figure 6-24
：
Scanning the ICP DAS module
iv.
After the Scan operation is completed, an M-7000/tM/DL/LC/iSN
module list will appear. If the newly scanned module doesn‟t match
the module previously set on the same address, a window will
appear (Figure 6-26), please select the actual device that are
connected to WISE. After all settings are completed, click “Save”
button to save the changes.
