ICP DAS WISE User Manual
http://wise.icpdas.com
160
Fridays to be “In Range”, and Saturdays and Sundays to be
“Out of Range”, that is, the operations will be executed during
weekdays only. On the contrary, the
“Select Weekend”
button is
for you to set all Saturdays and Sundays to be “In Range”, and
all Mondays to Fridays to be “Out of Range”, that is, the
operations will be executed during weekends only.
Repeat:
(a.)
In the “Day(s) of week” section, click on the day(s) in a week
that is going to execute the schedule; shown as below:
Figure 9-9
：
Repeat mode of Schedule setting
(b.)
In the “Exception Date(s)” selection, click on “Add” to add the
date(s) that is/are not in the schedule. Click “Remove” to
remove a pre-set Exception Date.
(c.)
In the “Time Range(s)” section, click “Add” to add new Time
Range of this schedule. Select the start time and the end time
from the dropdown list. User can also enable the “Hourly”
option for the “Time Range” seting to launch the schedule with
the set date. Each Schedule is required to set at least one Time
Range; click on “Add” to add more Time Range.
Please note:
the time zones you specified can‟t be overlapped.
If you specify
an end time that is earlier than the start time, such as 20:00:00 ~
06:00:00, it indicates the end time will be set one day after the
start date. Click “Remove” to remove a pre-set Time Range.
