ICP DAS WISE User Manual
http://wise.icpdas.com
62
Figure 6-7
：
Remote I-7000/DL Module Setting Page
The following section will give more information how to add and complete
settings of I-7000/DL DCON modules. After all settings are completed,
click “Save” button to save the changes.
Please note:
1.
The COM3 (RS-485) and COM4 (RS-485) interfaces on WISE allows
connections to I-7000/DL DCON modules or Modbus RTU modules.
2.
A single COM Port interface (COM3 or COM4) allows connections to
at most 16 devices (I-7000/DL DCON modules or Modbus RTU
modules).
6.2.1 Scan to Add ICP DAS I-7000/DL DCON Modules
The user could use the Scan function to add ICP DAS I-7000/DL
DCON modules to the WISE, the steps are as below:
i.
Click on
button to scan the I-7000/DL DCON modules that are
connected to the WISE.
Figure 6-8
：
The “Scan” button to search I-7000/DL Modules
ii.
When the Scan page appears, input the starting address and the
ending address of the DCON address that are going to perform scan.
Click on “Scan”, the system will start to scan the I-7000/DL DCON
modules that match the settings previously set, to cancel the scan,
and click on “Cancel”.
