IBM System Storage TS3310, Maintenance Information

Page: 305 / 531

Replacing the Y Motor in the Y-axis/Picker Assembly in a
Stand-alone Library
1.
Ensure that the black plastic piece on the wiring end of the motor (
1
in
Figure 8-64) fits into the slot in the base plate (
2
in Figure 8-64).
Note: The top of the motor (
4
in Figure 8-64) must be parallel with the Picker
guide rod (
5
in Figure 8-64).
2.
Install the Y Motor in the Y-axis/Picker Assembly and tighten the thumb screw.
The small gear on the Y Motor must connect with the larger gear on the
Y-axis/Picker Assembly.
3. Connect the small white connector (
2
in Figure 8-65 on page 8-64).
Important: Be very careful not to damage the connector.
4. Connect the large black connector. See Figure 8-65 on page 8-64.
a66mi006
1
2
3
4
5
Figure 8-64. Correct Y motor position
Chapter 8. Add, Check, Adjust, Remove, and Replace Procedures
8-63