IBM BladeCenter JS12, Problem Determination And Service Manual

Page: 286 / 318

4. Install the blade server into the BladeCenter unit. See “Installing the blade
server in a BladeCenter unit” on page 242.
Removing the expansion bracket
You can remove the expansion bracket.
Perform the following procedure to remove the expansion bracket.
1. Read “Safety” on page v and the “Installation guidelines” on page 239.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing the blade server from a
BladeCenter unit” on page 241.
3.
Carefully lay the blade server on a flat, static-protective surface, with the cover
side up.
4. Open and remove the blade server cover. See “Removing the blade server
cover” on page 244.
5. If a standard-form-factor expansion card is installed, remove it. See “Removing
a standard-form-factor expansion card” on page 263.
6. Remove the two screws that secure the expansion bracket to the system board
and remove the expansion bracket.
7. If you are instructed to return the expansion bracket, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Expansion bracket
Figure 28. Removing the expansion bracket
272
JS12 Type 7998: Problem Determination and Service Guide