IBM BladeCenter JS12, Problem Determination And Service Manual

Page: 268 / 318

1. Read “Safety” on page v and the “Installation guidelines” on page 239.
2.
Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing the blade server from a
BladeCenter unit” on page 241.
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
side up.
4. Open and remove the blade server cover. See “Removing the blade server
cover” on page 244.
5. Locate the management card connector.
See “System-board connectors” on page 9 for the management card slot
location.
Attention:
To avoid breaking the card retaining clips or damaging the
management card connectors, open and close the clips gently.
6. Carefully open the retaining clips on each end of the management card
connector and remove the management card.
7. If you are instructed to return the management card, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
8. Move the management card to a new system board and chassis assembly.
If you are directed to move the management card to a new system board and
chassis assembly, perform the following procedure.
a.
Replace the system board and chassis assembly, as described in “Replacing
the Tier 2 system-board and chassis assembly” on page 274.
b. Replace the management card, as described in “Installing the management
card.”
Installing the management card
Use this procedure to install the management card into the currently installed
system board. If you are also installing a new system board, you must complete
this procedure before installing the new system board.
To install the management card, complete the following steps.
Management
card
Retaining clip
Figure 17. Installing the management card
254
JS12 Type 7998: Problem Determination and Service Guide