IBM BladeCenter JS12, Problem Determination And Service Manual

Page: 264 / 318

6. Install the appropriate drive.
v
Install the front SAS hard disk drive:
a. Unlatch the bezel to increase the ease of installing the drive. (You do not
have to remove the bezel.)
b. Place the drive into the hard disk drive tray and push it toward the rear
of the blade, into the connector until the drive moves past the lever at the
front of the tray.
Attention: Do not press on the top of the drive. Pressing the top might
damage the drive.
c. Latch the bezel.
v
Install the rear SAS hard disk drive:
a. If a standard-form-factor expansion card is installed in the rear drive SAS
connector 1 location, remove the expansion card, remove the expansion
card and its mounting bracket, and save the screws that secure the tray to
the system board. Store the screws in a safe place.
b. Secure the SAS connector drive tray to the system board with the screws
from the option kit.
c. Place the drive into the hard disk drive tray and push it toward the rear
of the blade, into the connector until the drive moves past the lever at the
front of the tray.
Attention: Do not press on the top of the drive. Pressing the top might
damage the drive.
7.
Install and close the blade server cover. See “Installing and closing the blade
server cover” on page 245.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
8. Install the blade server into the BladeCenter unit. See “Installing the blade
server in a BladeCenter unit” on page 242.
250
JS12 Type 7998: Problem Determination and Service Guide