IBM BladeCenter JS12, Problem Determination And Service Manual

Page: 279 / 318

6. Install the expansion bracket. See “Installing the expansion bracket” on page
273.
7.
Touch the static-protective package that contains the part to any unpainted
metal surface on the BladeCenter unit or any unpainted metal surface on any
other grounded rack component; then, remove the part from its package.
8. Orient the expansion card and slide the notch in the narrow end of the card
into the raised hook on the expansion bracket; then, gently pivot the wide end
of the card into the expansion card connectors.
9. Install and close the blade server cover. See “Installing and closing the blade
server cover” on page 245.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade server cover before installing the
blade server.
10.
Install the blade server into the BladeCenter unit. See “Installing the blade
server in a BladeCenter unit” on page 242.
11. Use the documentation that comes with the expansion card to install device
drivers and to perform any configuration that the expansion card requires.
Removing a combination-form-factor expansion card
Complete this procedure to remove a combination-form-factor expansion card.
Expansion cards
Figure 22. Removing a combination-form-factor expansion card
Chapter 4. Removing and replacing blade server components
265