
Chapter 5 I/O Parameter
95
Chapter 5 I/O Parameter
Parameter data should be set appropriately according to the applicaiton requirements. When a
change is required to the parameters, make sure to back up the data before the change so the
settings can be returned anytime.
With using PC software, it is able to store the backup to the PC.
For a teaching pendant applicable for memory card (TB-01/TB-02/TB-03), back up the data to a
memory card. Make notes in case there is no memory card available.
Also, for the purpose of rapid recovery after the investigation of failure unit or replacing the
controller, keep data backup or memo also after the parameter change.
The change to the parameters will be activated after they are edited, written to the flash ROM, then
either software reset or reboot of the power. It will not be active only with writing on the teaching
tool.
The initial settings (reference) described in the tables in the sections from 5.1 I/O Parameters to 5.7
Other Parameters may differ depending on the connected actuators and control systems.
The range for input is the range that a teaching tool can apply. In the actual setting, input a value in
the remark column which activates the functions. (Do not attempt to input the values other than
those defined in the remarks.)
Warning: Establishment of parameter setting gives a great influence to operation.
Wrongly established setting could cause not only an operation error or
malfunction, but also it is very dangerous.
Settings at the delivery enable the product to operate standardly. Understand
very well about the control logic of controller if making a change or performing a
setting suitable to the system. Please contact us if you have anything unclear.
Do not turn OFF the power to the controller during the parameter writing.
Summary of Contents for MSEL
