HP StorageWorks 2/140 - Director Switch, Service Manual

Page: 106 / 396

Diagnostics
106 Director 2/140 Service Manual
■
Audio emanations and airflow from cooling fans.
Is the director powered on?
YES NO
↓
A power distribution problem is indicated. Go to “ MAP 0100: Power
Distribution Analysis ” on page 69. Exit MAP.
28
At the director, inspect the amber LED at the top of each CTP card.
Is the amber LED illuminated on both CTP cards?
NO YES
↓
Failure of both CTP cards is indicated. Go to “ MAP 0500: FRU
Failure Analysis ” on page 107. Exit MAP.
29
Either a director-to-PC Internet link problem (Internet too busy or IP address
typed incorrectly) or a director Ethernet port failure is indicated.
1. Wait approximately five minutes, then attempt to log in to the director again.
2. At the Netsite field (Netscape Navigator) or Address field (Internet
Explorer), type
http://xxx.xxx.xxx.xxx
, where
xxx.xxx.xxx.xxx
is the IP address of the director (obtained in “ MAP
0000: Start MAP ” on page 45). The Username And Password Required dialog
box displays.
3. Type the username and password obtained in “ MAP 0000: Start MAP ” on
page 45 and click OK. If the View panel does not display, wait five minutes
and perform this step again.
Is the Embedded Web Server interface operational with the View panel
displayed?
NO YES
↓
The director-to-Web server PC connection is restored and is
operational. Exit MAP.
Failure of the CTP card’s Ethernet port is indicated. Go to “ MAP 0500: FRU
Failure Analysis ” on page 107. Exit MAP.