Horizon Hobby ??11, Operation Manual

Page: 44 / 124

42
▋
Throttle▋trim【THRO▋TRIM】
▋
▋
Function▋Explanation
This function sets the Throttle Trim movement, and additionally a Throttle Cut function is
provided for cutting the engine. There is a Trim Memory function for cutting the engine using
the Trim. Note that for airplanes, an Idle Adjust function is also incorporated that allows separate
detailed setting of the idle position.
▋
▋
Setting▋Method
If the Throttle Cut is set to ACT, the Trim Memory will
be forcibly set to INH. On the screen rotate the dial to
move to and select (inverse display), then press the
dial to set the item.
⿟ Throttle Cut Function (THRO CUT)
The Throttle cut can be used by setting it to “ACT”.
Initially the switch is allocated to “TRN SW”, POS1. It
is possible to allocate this switch to any desired
switch location. Set the Throttle Cut to the desired
position.
፧ Time Lag (TIME LAG)
This function is to avoid the sudden stopping of the engine if the throttle cut switch is activated in error. This
is especially useful when using the momentary switch (Trainer switch). It is possible to use this momentary
switch as timer switch at the same time as throttle cut. When the time lag function is activated, throttle cut
only activates when the switch is held on for a certain duration. The timer can be activated by a momentary
action as usual. The time lag duration can be set between 0.5 to 2 seconds.
⿟ Throttle Trim Memory (THRO TRIM MEMORY)
When the Trim is lowered in a single action, the trim position immediately prior to the movement will be
memorized, and when the trim is raised again, the trim will automatically return to the memorized position. The
memorized position will be marked on the Trim display.
⿟ Idle Adjust (IDLE ADJUST) ※ For Airplane Mode only
The idle posit ion when
the throttle stick is at the
“Slow” position can be given
a separate setting using a
switch. It is possible to set up
landing with idle “DOWN”,
and normal flying with idle
“UP”.
⿟ Please carefully confirm the linkage does not jam when the carburetor’s is closed.
▋
▋
Caution▋Note
⿟ Throttle Cut will only work when the helicopter Flight Mode is set to “NORMAL”.
Function▋List
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Throttle Cut Trim Memory
Time Lag
Throttle Cut Trim Memory
Time Lag
Throttle Cut Trim Memory
Time Lag
ダイヤル
TIPS
調整ポイント表示
ポイント接続を曲線に変更 スティック入力位置と出力位置の数値表示
現在の
フライトモード位置
各調整ポイントの
入力位置と出力位置
ポイントの
追加と削除
注意：
グラフはホバリン
グスロットルやス
ロットルトリムで
変化する場合もあ
ります。
カーブをコピー
XG11.indd 42 12/01/19 12:30