Horizon Hobby ??11, Operation Manual

Page: 88 / 124

86
▋
Telemetry▋System【TELEMETRY】
▋ ▋ Function▋Explanation
This allows confirmation of the telemetry sensors present in a particular aircraft, gathering
information such as Receiver Voltage, Altitude, Temperature or Propeller or rotor blade r.p.m.,
etc. In addition to the data on the display, alarms are used, so as aircraft conditions can be
monitored without taking your eyes off the aircraft.
▋ ▋ Setting▋Method
▋ ▋ Receiver▋battery▋(RX-BATT)▋/▋
▋No▋Link▋Alarm▋(NO▋LINK▋ALARM)
⿟ Receiver battery alarm
This function alerts to a drop in receiver battery voltage.
Initially it is inhibited. To activate, set the alarm Voltage
between 3.0V – 9.0V in 0.1V increments.
⿟ No Link Alarm
This will warn when the transmitter is no longer receiving
data from the model. Initially it is set as inhibited. Set the
delay after which the alarm should sound to either 10S
(10 seconds), 15S (15 seconds), 20S (20 seconds), 30s (30
seconds).
▋ ▋ Temperature▋(TEMPERATURE)
⿟ Unit (SCALE)
This selects the units for temperature display - Celcius (°C)
or Farenheit (°F). Select the units as desired.
⿟ Alarm (ALARM)
This sets the temperature at which the alarm will sound
– between 30 and 500°C. Initially this alarm is inhibited.
Set the temperature to the desired alarm point.
▋ ▋ Revolutions▋Per▋Minute▋(RPM)
⿟ Gear Ratio (GEAR RATIO)
It is possible to monitor the Helicopter’s actual rotor
blade r.p.m. by entering the gear ratio. Check the gear
ratio for each Helicopter by checking your manual.
Initially it is set as inhibited. Set the necessary numerical
value. Gear Ratio can be set between 1.00〜20.00 in 0.01
increments.
⿟ Number of Blade (PROPELLER)
It is possible to monitor an Airplane’s actual Propeller r.p.m by installtion of an optical sensor. It is necessary
to input the number of blades for the propeller in order to have actual Propeller r.p.m displayed. Initially, it is
inhibited. The number of Propeller blades can be set between 1-20.
⿟ Delay (DELAY)
It is possible to display and store the maximum r.p.m. recorded in each flight mode. However, when the flight
mode is changed, the sensor may immediately store a maximum value, which would be invalid. To avoid storing
incorrect r.p.m. data, this function allows rpm to stabalise before storing any data. Initially it is set to inhibited.
Set the desired numerical amount which would suit with your model. The delay can be set from 0.5s (0.5
seconds) ~ 10.0s (10 seconds) in 0.5 seconds increments.
System▋List▋
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
XG11.indd 86 12/01/19 12:30