56
▋
Camber▋sytem【CAMBER▋SYSTEM】
▋
▋
Function▋Explanation
It is possible to set an airplane (Glider in particular) which has full span ailerons or flaps +
ailerons on the main wing giving full-span moveable control surfaces. These control surfaces can be moved up
and down simultaneously to change the wing type. Because changing the wing type can vary the rate of descent
and the drag, it is possible to change the flight endurance and the glide ratio. These settings can be set for each
Flight Mode. In addition, because the delay time during transition can be adjusted, the aircraft will not react
wildly. During this delay time, rapid cancellation is possible using the elevator stick. (Break Function)
▋
▋
Setting▋Method
There are two ways of setting the amount of Camber offset in each flight mode. One is to set it using this
function, and the other method is changing the Trim position.
It is possible to set the numerical value of Camber off-set with a desired “DELAY” and “BREAK” in the menu.
Off Set Value (OFFSET)
Set the Offset value on both FLAP and Flaperon for each flight mode.
፧
FLAPERON
Set each Flaperon value for the Left Aileron and Right Aileron.
፧
FLAP
Set single Flap using “FLAP”, For “Dual Flaps” set the “LFLP” (Left Flap) and “RFLP” ( Right Flap) values
independently.
Time Delay (DELAY)
Set the Time delay when switching between different flight mode. “INH” is no Time Delay. The time delay
duration can be set between 0.1 to 6.0 seconds. “HOLD” means withouts Time Delay.
፧
Flap Trim
「FLAP TRIM」
፧
Flaperon Trim
「FPRN TRIM」
፧
Elevator Trim
「ELEV TRIM」
Break Function (BREAK / BREAK BY ELEV STICK)
This sets the range of the Break function using the Elevator Stick. This can be “INH” or “ACT”. Because the delay
operation will be discontinued even if the stick exceeds the numerical value only momentarily, it allows you to
respond to sudden changing circumstances. Set the position (numerical value) for the elevator where it should
“ACT” using the “BREAK BY ELEV STICK” function.
Function▋List
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Break Function(BREAK / BREAK BY ELEV STICK)
Time Delay(DELAY)
Offset Value (OFFSET)
XG11.indd 56
12/01/19 12:30
Summary of Contents for ??11
