Horizon Hobby ??11, Operation Manual

Page: 71 / 124

69
▋
SERVO▋MONITOR【MONITOR】
▋ ▋ Function▋Explanation
This function allows simulation of servo operation on the transmitter. Because this gives a
‘final output’ of all servo signals, provisional confirmation can be carried out before actually
connecting the servos. Further, this is useful for discovering unintentional mixing and switch
setting mistakes.
▋ ▋ Setting▋Method
Servo test outputs are displayed on the screen. Operate each control and switch and carefully
confirm the settings.
⿟ SERVO TEST
A Servo Test can be carried out within this function mode. Select the required servo test from below four options.
Also note that if a Limit Adjust has been set (on the function List), servos will not move further than is allowed by
the limit setting. In this way you can avoid damaging servos or linkages on the aircraft.
INH: Invalid.
NEUTRAL: Set all the servos to their Neutral positions.
SLOW: All servos simultaneously move at Low speed linearly using ± 100% travel.
QUICK: All servos simultaneously move at High speed linearly using ± 100% travel.
STEP: Each channel’s servo sequentially moves on each side in turn using 100% travel.
⿟ Confirmation of trim movement
By viewing the first Servo Monitor Page, it is possible to check the trim step amount as shown in the below
screen shot.
Function▋List
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Position Selection
Servo Test Servo Test
Position Selection
Servo Test Servo Test
XG11.indd 69 12/01/19 12:30