Horizon Hobby ??11, Operation Manual

Page: 62 / 124

60
▋
Elevator▋to▋Camber▋Mixing▋
【ELEV → CAMB▋MIX】
▋
▋
Function▋Explanation
This function applies mixing to the main wing camber (Center line of Airfoil) based on elevator operation.
Adjustment of the wing root flaps and wing tip flaperons separately in both up and down direction is possible.
This function can be set for each Flight Mode.
▋
▋
Setting▋Method
The mix amount to the Flaps and Flaperons can be set on each flight mode, with elevator up and down directions
set individually.
⿟ Mixing Offset on reference point (OFFSET)
By utilizing offset, the reference point where the mixing starts can be optimised.
⿟ Snap Activation function (SNAP)
By setting SNAP to “ACT”, when the elevator stick reaches the position of the value that was set using OFFSET,
the flaps and flaperons will move to the position that was set.
ダイヤル
TIPS
調整ポイント表示
ポイント接続を曲線に変更 スティック入力位置と出力位置の数値表示
現在の
フライトモード位置
各調整ポイントの
入力位置と出力位置
ポイントの
追加と削除
注意：
グラフはホバリン
グスロットルやス
ロットルトリムで
変化する場合もあ
ります。
カーブをコピー
⿟ The so-called air combat flaps (snap flaps) can be used in aircraft with main wings that have a 3-servo (channel)
structure. To maximise stability, reducing the mixing amount to the wing tip ailerons rather than the wing root
flaps will cause an effect that reduces wing twisting and achieves improved stability.
▋ ▋ Caution▋Note
⿟ Actually operate the servos and carefully confirm the settings before flying.
Function▋List
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Mixing Offset on reference point(OFFSET)
Snap Activation function (SNAP)
XG11.indd 60 12/01/19 12:30