HTTP/HTTPS
W
EB
GUI
–
W
EB
B
ROWSER
C
ONFIGURATION
I
NTERFACE
8029HEPTA-V2/GPS GPS - NTP Time Server with LAN Interface - V08.00
55 / 130
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
8.3.2.2.2 Customer Hardware Address (MAC)
The MAC address assigned from
hopf
can be changed to any user-defined MAC address.
The board identifies itself with the user-defined MAC address to the network. The default
hardware address shown in WebGUI remains unchanged.
Double assignment of MAC addresses on the Ethernet referring to
customers MAC addresses should be avoided.
If the MAC address is not known, please contact your network
administrator.
The use of customers MAC address needs to be activated by the function
Use Custom
Hardware Address (MAC
) with
enable
and subsequently save it with
Apply
and
Save
.
Afterwards the customers MAC address has to be entered in hexadecimal form with a colon
to separate as described in the below example, e.g.
00:03:c7:55:55:02
The MAC address assigned by
hopf
can be activated at any time by
disabling this function.
There are no MAC multicast addresses allowed!
Finally, the module 8029HEPTA has to be restarted via "Device" -> "Reboot Device" (see
Chapter 8.3.5.4 Restarting the Module (Reboot Device)
8.3.2.2.3 DHCP
If DHCP is to be used, activate this with
enabled
.
8.3.2.2.4 IPv4 Address
If DHCP is not used, the IPv4 address needed to be entered here. Contact your network
administrator for details of the used IPv4 address if not known.
8.3.2.2.5 IPv4 Network Mask
If DHCP is not used, the network mask needed to be entered here. Contact your network
administrator for details of the used network mask if not known.
