4-58
Initialization setting
It is possible at any time to reinitialize the Inverter parameters back to there
factory default. The trip history can also be cleared at any time, however, if
problems occur it will be difficult to fault find without the trip history for reference.
Initialization details are as follows;
Set item
Function
mode
Data
Description
00
This clears only trip history.
01
This only initializes setting value.
Setting value becomes the state on factory
forwarding.
Initialization
selection
b084
02
This clears trip history and initializes setting.
00
Initializing setting for Japan.
01
Initializing setting for Europe
Initial data
selection
b085
02
Initializing setting for America.
(Initialization methods)
After setting the above parameters, initialize as follows;
Chapter 4 Explanation of function
b084: Initialization selection
b085: Initial data selection
Relation code
POW ER
%
A
ALAR M
RUN
PRG
V
H z
kW
1
2
H I T A C H I
MIN
MA X
STR
RUN
STOP/
RESET
FUNC
(1) Hold down the FUNC, UP and
DOWN key and then press the STR
key. When the display starts to flash
and rotate release all the keys.
(2) During initializing
Above display is for Japan.
Other displays are below.
(3) When “d001” is displayed in the
monitor, initialization is complete.
The display revolves on the left.
During initializing for Europe.
During initializing of trip history.
During initializing for America.
%
A
ALAR M
RUN
PRG
V
H z
kW
1
2
H I T A C H I
MIN
MA X
STR
RUN
STOP/
RESET
FUNC
POW ER
%
A
RUN
PRG
V
H z
kW
1
2
H I T A C H I
MIN
MA X
STR
RUN
STOP/
RESET
FUNC
ALAR M
POW ER
