152
_____________________________________________________________________________________________
6.4 File Screen
______________________________________________________________________________________________
6.4.3 Saving the Waveform Data (MEM)
Command:
WAVE
If a file with the same name already exists,
a warning message will appear
NOTE
Saves 8730-10, 8731-10 waveform data to a PC card.
The data is saved in binary format (MEM).
When data in MEM format is read by the 8730-10, 8731-10, the saved
waveform will appear on the screen.
Procedure
1. Press the
FILE
key, and display the File
screen.
2. Press the left
CURSOR
key to move the
cursor to a command.
3. Select "
WAVE
", then press the
ENTER
key.
4. Enter a filename. For details, see 8. in
3.1.2.
5. Use the up and down
CURSOR
keys to
move the cursor to "
CH
" and select the
channel for which to save data. Note
that selecting "-" for a channel will not
save the channel data.
6. Press the
START
key to save the data;
press the
STOP
key to cancel.
Starts saving.
Cancels saving.
If the amount of data is too large, the data
may not be successfully saved on the PC
card. For details, see 13.3.
If a file with the same name already exists,
a warning message will appear. Rename
the file in step 4. above or save the file by
one of the following two methods:
OVER WRITE : Overwrite the existing file.
NUMBERING: Append a number to the
filename.
When waveform calculation is enabled,
only calculated waveforms are saved.
