Hioki 3511-50, Instruction Manual, Page: 44 / 140

32
________________________________________________________________________________________________________________
4.3 Panel Load Function
________________________________________________________________________________________________________________
4.3.1 Setting Panel Load
COUNT
NOTE
4.3.2 Aborting Panel Load
4.3 Panel Load Function
You can read or load saved test conditions from internal memory.
(1) Press repeatedly to cycle through available settings: panel load, panel
save and normal test (or comparator test) modes. For more information on
panel save mode, see Section 4.2, "Panel Save Function."
(2) Enter panel load mode and specify the panel number to load. Use the
COUNT setting key to specify a panel number. If no test condition is set, as
on shipment or reboot, "--" is displayed as a panel number. In this state, no
panel number can be set.
keys increase/decrease the value.
move the cursor to a digit to be set (up to two digits).
The LED for the digit under setting flashes.
Each time a panel number is specified, the test conditions for the
corresponding panel are indicated by the LED lamp. You cannot select
panel numbers that are not panel-saved.
permit automatic specification of a panel number if it is panel-saved.
The set values must fall between 01 and 99.
(3) After specifying a panel number, press . The 3511-50 loads the test
conditions and reverts to normal or comparator test mode.
After specifying a panel number in panel load mode, press instead of
. The 3511-50 moves to panel save mode without performing the
panel load. Press again. The 3511-50 reverts to normal or
comparator test mode.