Hioki 3511-50, Instruction Manual, Page: 22 / 140

10
_____________________________________________________________________________________________________________
2.3 Turning the Power On and Off
________________________________________________________________________________________________________________
NOTE
NOTE
2.3 Turning the Power On and Off
How to turn the power on
Turn on the power switch on the rear panel. All LEDs on the front panel
light.
The test conditions will start off the same as they were when last the power
was turned off.
Wait for 60 minutes after turning on the power before starting testing, so as
to allow the unit to warm up fully.
How to turn the power off
Turn off the power switch on the rear panel. The test conditions will be
preserved.
Even if the power supply is interrupted because of a power failure or the
like, the test conditions (settings) will not be lost; when the power is turned
on again, the unit will return to its state just before the interruption.
This happens, however, in the normal test mode or comparator execution
mode only.