
Specifications
Chapter 1: Introduction
Electromagnetic Immunity Guidance
Guidance and Manufacturer's Declaration - Electromagnetic Emissions
The VersaCare™ Bed model P3200/P3201 is intended for use in the electromagnetic environment specified below. The
customer or the user of the model P3200/P3201 should make sure it is used in such an environment.
Immunity Test
IEC 60601
Test Level
Compliance Level
Electromagnetic
Environment—Guidance
Electrostatic
Discharge (ESD)
IEC 61000-4-2
± 6 kV Contact
± 8 kV Air
± 6 kV Contact
± 8 kV Air
Floors should be wood, concrete, or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Radiated RF
IEC 61000-4-3
3 Vrms
80 MHz to 2.5 GHz
3 Vrms
80 MHz to 2.5 GHz
Portable and mobile RF communica
tions equipment should not be used
at close distances to the
P3200/P3201 bed. (See Note 2)
Electrical Fast
Transient/Burst
IEC 61000-4-4
± 2 kV on Power Supply
Lines
± 1 kV on Input/ Output
Lines
± 2 kV on Power Supply
Lines
± 1 kV on Input/Output
Lines
Mains power quality should be that
of a typical commercial or hospital
environment.
Surge
IEC 61000-4-5
± 1 kV Differential Mode
(line-line)
± 2 kV Common Mode
(Line-Ground)
± 1 kV Differential Mode
(line-line)
± 2 kV Common Mode
(Line-Ground)
Mains power quality should be that
of a typical commercial or hospital
environment.
Conducted RF
IEC 61000-4-6
3 Vrms
150 kHz to 80 MHz
3 Vrms
150 kHz to 80 MHz
Portable and mobile RF communica
tions equipment (cell phones) should
not be used at close distances to the
P3200/P3201 bed. (See Note 2)
Power Frequency
Magnetic Fields
IEC 61000-4-8
3 A/m
3 A/m
The power frequency magnetic field
should be measured in the intended
installation location to assure it is
sufficiently low.
Voltage Dips, Short
Interrupts, and Varia
tions On Power Sup-
ply Lines
IEC 61000-4-11
< 5% U
T
(95% dip in U
T
for 0.5
cycles)
< 40% U
T
(60% dip in U
T
for 5
cycles)
< 70% U
T
(30% dip in U
T
for 25
cycles)
< 5% U
T
(95% dip in U
T
for 5 sec
onds)
(See Note 1)
< 5% U
T
(95% dip in U
T
for 0.5
cycles)
< 40% U
T
(60% dip in U
T
for 5
cycles)
< 70% U
T
(30% dip in U
T
for 25
cycles)
< 5% U
T
(95% dip in U
T
for 5 sec
onds)
Mains power quality should be that
of a typical commercial or hospital
environment. If operation is required
during an extended power outage or
interruption, the model
P3200/P3201 should be switched to
operate from the backup battery.
Note 1: U
T
is the AC mains voltage prior to application of the test level.
Page 1 - 10
VersaCare™ Bed Service Manual (MAN333 REV 2)
Summary of Contents for VersaCare P3200
