Hill-Rom VersaCare P3200, Service Manual

Page: 203 / 379

4.20 Load Beam
Chapter 4: Removal, Replacement, and Adjustment Procedures
c. Remove the screw (J) and washer (K) from the end of the load beam
(L).
d. Remove the two bolts (M) securing the block (N) to the intermediate
frame (O).
e. Remove the block (N) from the intermediate frame (O).
f. Remove the block (N) from the load beam (L).
g. Remove the two screws (P) securing the load beam (L) to the bed (C).
h. Remove the channel cover (Q).
i. Remove the load beam (L) from the bed (C).
NOTE:
The string will act as a pull string for routing the new load beam cable through
the bed during installation.
13. For the right head end load beam, do the following:
a. Remove the screw (R) and washer (S) from the end of the load beam
(X).
b. Remove the outer plastic spacer (T) from the load beam (X).
c. Remove the two bolts (U) securing the block (V) to the intermediate
frame (O).
d. Remove the block (V) from the intermediate frame (O).
e. Remove the inner plastic spacer (T) from the load beam (X).
f. Remove the two screws (W) securing the load beam (X) to the
intermediate frame (O).
g. Remove the load beam from the bed (C).
NOTE:
The string will act as a pull string for routing the new load beam cable through
the bed during installation.
Replacement
1. Do the removal procedure in reverse order.
2. Calibrate the scale (see “Scale Calibration” on page 6-12).
3. To make sure the VersaCare™ Bed operates correctly, do the “Function
Checks” on page 2-6.
4
VersaCare™ Bed Service Manual (MAN333 REV 2) Page 4 - 71