Hill-Rom VersaCare P3200, Service Manual

Page: 220 / 379

4.27 Sensor Strip
Chapter 4: Removal, Replacement, and Adjustment Procedures
6. For the two outer sensor strips (H) on the head section, do the following:
a. Remove the 11 screws (K) securing the air module cover (L) to the
sleep deck (J) (see figure 4-45 on page 4-88).
Figure 4-45. Air Module Sensor Strip
b. Remove the air module cover (L).
c. Disconnect the sensor cable (M) from the air control P.C. board (N).
d. Using the punch and hammer, punch out the center of the four rivets (I)
securing the sensor strip (H) to the sleep deck (J) (see figure 4-44 on
page 4-87).
e. Remove the sensor strip (H) from the sleep deck (J).
Replacement
1. Do the removal procedure in reverse order.
2. To make sure the VersaCare™ Bed operates correctly, do the “Function
Checks” on page 2-6.
Page 4 - 88 VersaCare™ Bed Service Manual (MAN333 REV 2)