Hill-Rom VersaCare P3200, Service Manual

Page: 172 / 379

4.14 Foot Hilow Motor
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.14 Foot Hilow Motor
Tools required: T25 Torx®
1
screwdriver
13 mm wrench
Antistatic strap
Wire cutters
Service kit—drive replacement (130016)
Removal
1. Set the brakes.
2. Raise the head section to the highest position.
3. Raise the knee section to the highest position.
SHOCK HAZARD:
Unplug the bed from its power source. Failure to do so could cause
personal injury or equipment damage.
4. Unplug the bed from its power source.
5. Remove the three screws (A) that attach the cover (B) to the bed (C) (see
figure 4-18 on page 4-41).
6. Remove the cover (B).
7. Remove the two screws (D) that attach the electronics module cover (E) to
the electronics module (F).
8. Remove the electronics module cover (E).
9. Cut and remove any cable ties that attach the foot hilow drive cable to the
electronics module (F).
CAUTION:
When handling electronic components, wear an antistatic strap. Failure
to do so could cause component damage.
10. Put on the antistatic strap.
11. Disconnect the foot hilow drive cable from the motor control P.C. board
inside the electronics module (F).
1. Torx® is a registered trademark of Textron, Inc.
Page 4 - 40 VersaCare™ Bed Service Manual (MAN333 REV 2)