Hill-Rom VersaCare P3200, Service Manual

Page: 204 / 379

4.21 Battery
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.21 Battery
Tools required: T20 Torx®
1
screwdriver
T25 Torx® screwdriver
Wire cutters
Removal
NOTE:
The batteries must be replaced in pairs.
1. Set the brakes.
SHOCK HAZARD:
Unplug the bed from its power source. Failure to do so could result in
personal injury or equipment damage.
2. Unplug the bed from its power source.
NOTE:
If the battery function is active, the bed must be plugged in, then unplugged to
deactivate the battery.
3. Remove the six screws (A) securing the power supply module cover (B) to
the bed (C) (see figure 4-36 on page 4-73).
4. Remove the cover (B).
5. Make note of the position of the cables on the batteries (D).
6. Remove the cable tie (G) from the wire bundle (H).
7. Disconnect the cables on the batteries (D).
8. Remove the screw (E) securing the bracket (F) to the bed (C).
9. Remove the bracket (F).
WARNING:
If battery fluid touches skin or clothing, immediately wash it off with
clean water. If battery fluid c gets in the eyes, immediately flush them
with water and consult a physician. Failure to do so could result in
personal injury.
1. Torx® is a registered trademark of Textron, Inc.
Page 4 - 72 VersaCare™ Bed Service Manual (MAN333 REV 2)