Hill-Rom VersaCare P3200, Service Manual

Page: 169 / 379

4.13 Air Module
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.13 Air Module
Tools required: T25 Torx®
1
screwdriver
Removal
1. Set the brakes.
2. Raise the bed to the high position.
3. Remove the mattress, (refer to procedure 4.1).
4. Raise the head section to the highest position.
SHOCK HAZARD:
Unplug the bed from its power source. Failure to do so could result in
personal injury or equipment damage.
5. Unplug the bed from its power source.
6. Remove the 11 screws (A) securing the module cover (B) to the head
section (C) (see figure 4-16 on page 4-38).
7. Remove the module cover (B).
8. Remove the two screws (D) securing the module (E) to the head section
(C).
9. Disconnect all of the cables (F) on the module P.C. board (G) (see figure 4-
17 on page 4-38).
10. Disconnect the air hose (H) from the hose connector (I).
NOTE:
Do not disconnect the air hoses between the manifold block and the P.C. board.
11. Carefully slide the module (E) out of the head section (C) (see figure 4-16
on page 4-38).
4
1. Torx® is a registered trademark of Textron, Inc.
VersaCare™ Bed Service Manual (MAN333 REV 2) Page 4 - 37