Hill-Rom VersaCare P3200, Service Manual

Page: 179 / 379

4.15 Head Hilow Motor
Chapter 4: Removal, Replacement, and Adjustment Procedures
Figure 4-22. Cover Removal
4
12. Remove the drive cable from the bed.
13. Remove the two screws (not shown) that attach the electronics module (F)
to the bed (C).
14. Move the electronics module (F) to the side.
15. It is not necessary to disconnect the cables inside the electronics module.
16. If the bed is in the lowest position, do as follows, otherwise go to step 17:
a. Put the scissor jack (G) under the torque tube (H) (see figure 4-23 on
page 4-48).
b. Raise the jack (G) so there is approximately 6" (15 cm) between the
intermediate frame (I) and the base frame (J).
c. It may be necessary to push down on the base frame to separate the
intermediate frame (I) from the base frame (J).
d. Remove the jack (G).
17. Install the hoist (K) so the hooks (L) catch on the shafts (M) (see figure 4-
24 on page 4-49).
VersaCare™ Bed Service Manual (MAN333 REV 2) Page 4 - 47