Hill-Rom VersaCare P3200, Service Manual

Page: 143 / 379

4.4 Head Siderail
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.4 Head Siderail
Tools required: T25 Torx®
1
screwdriver
E-ring installation tool
Screwdriver
Removal
1. Set the brakes.
2. Raise the bed to the high position.
3. Raise the head section to the highest position.
4. Raise the siderail being changed to the up and locked position.
SHOCK HAZARD:
Unplug the bed from its power source. Failure to do so could result in
personal injury or equipment damage.
5. Unplug the bed from its power source.
6. Remove the screws (A) securing the cover (B) to the bed (C) (see figure 4-
5 on page 4-12).
7. Remove the cover (B).
8. Remove the two screws (D) securing the electronics module cover (E) to
the electronics module (F).
9. Remove the electronics module cover (E).
10. Remove the two screws (G) securing the cable cover (H) to the head
section (I) (see figure 4-6 on page 4-13).
NOTE:
The screws being removed should be on the same side as the siderail being
replaced.
11. Cut and remove the cable ties (J) securing the siderail cable to the head
section (I).
4
1. Torx® is a registered trademark of Textron, Inc.
VersaCare™ Bed Service Manual (MAN333 REV 2) Page 4 - 11