Hill-Rom VersaCare P3200, Service Manual

Page: 173 / 379

4.14 Foot Hilow Motor
Chapter 4: Removal, Replacement, and Adjustment Procedures
Figure 4-18. Cover Removal
4
12. Remove the drive cable from the bed.
13. If the bed is in the lowest position, do as follows, otherwise go to step 14:
a. Put the scissor jack (G) under the torque tube (H) (see figure 4-19 on
page 4-42).
b. Raise the jack (G) so there is approximately 6" (15 cm) between the
intermediate frame (I) and the base frame (J).
NOTE:
It may be necessary to push down on the base frame to separate the
intermediate frame from the base frame.
c. Remove the jack (G).
14. Install the hoist (K) so the hooks (L) catch on the shafts (M) (see figure 4-
20 on page 4-43).
NOTE:
If the IntelliDrive® Transport System drive box is installed, the hoist goes on
top of the drive box.
VersaCare™ Bed Service Manual (MAN333 REV 2) Page 4 - 41